Jump to content

Leaderboard

Popular Content

Showing content with the highest reputation on 12/22/2018 in all areas

  1. OK - I'm not much of a plubmer and don't know too much about plumbing problems.... but I'm pretty good with my hands and can usually figure stuff out... I was trying to unclog my bathroom sink drain. I plunged after blocking-off the other outlets on the system - the plunging usually works, but not this time. My building was built around the turn of the century, so the plumbing is a bit dodgy (and I definately CAN'T use chemicals...) so I went and purchased a small plumbers auger and went back at it. I have cleared the drain (water runs freely now) BUT I can't get my auger back out. It's stuck in the drain! Pissed me off.... So any of you do it yourselfers have a suggestion on how to get it out?
    1 point
  2. Why Azatik, what was on your mind... http://queerhye.delri.net/amot.gif
    1 point
  3. Vava jan,sorry about your problem.Here what I found Insert the guide tube with the curve facing the direction of the drain. Some bowls drain to the front and some drain to the rear. Crank the auger in one direction until is becomes tight then crank in the other direction. Repeat this until the auger is in as far as it will go. Crank the auger to clear the obstruction. Pull the guide tube out of the toilet. If it gets stuck push and pull gently or turn a crank back and forth while gently pulling up. Do not force the auger or you may break the toilet bowl. Repeat the process using the plunger. If the water seems to be properly draining, go ahead and try flushing the toilet Also in my simple thinking I also think some kind of oil may help sliding it out.I am thinking corn oil It is safe since it is not a petro base.I would heat the oil little and pure in the hole and after five min gently start pulling and pushing the auger. get back.good luck
    1 point
×
×
  • Create New...